Smok-E Mountain VREX Der 30mm Vanilla

Wichtig: Die Akkuträger sind neu und verpackt Allerdings befindet sich die Verpackung aufgrund ihres Alters
und des Materials in einem schlechten Zustand. Dies hat keinen Einfluss auf den Akkuträger selbst.

Genialer Akkuträger aus dem Hause Smok E Mountain 30mm Durchmesser und 100mm länge

VREX SS (Stainless Steel) -Full Mechanical -26650 Tube Mod -316 Stainless Steel -Full Copper Pins -30mm diameter -standard 510 connection -adjustable throw button with lock ring -serialized engraving -smok-e mountain logo engraved


VREX COPPER -Full Mechanical -Stainless Steel Lock ring -Stainless Steel Top Cap -Brass Bottom Assembly -Copper 26650 Tube -Full Copper Pins -30mm diameter -standard 510 connection -adjustable throw button with lock ring -serialized engraving -smok-e mountain logo engraved


VREX Titanium -Full Mechanical -Titanium 26650 tube mod -Full Copper Pins -30mm diameter -standard 510 connection -adjustable throw button with lock ring -serialized engraving -smok-e mountain logo engraved -lightweight


VREX Rhodium -Full Mechanical -Rhodium Plated 26650 tube mod -Rhodium Pins -30mm diameter -standard 510 connection -adjustable throw button with lock ring -serialized engraving -smok-e mountain logo engraved


VREX Brass Glazed -Full Mechanical -Ceramic Coated Brass 26650 tube mod (non-tarnish) -Full Copper Pins -30mm diameter -standard 510 connection -adjustable throw button with lock ring -serialized engraving -smok-e mountain logo engraved


VREX Brass -Full Mechanical -Brass 26650 tube mod (non-tarnish) -Full Copper Pins -30mm diameter -standard 510 connection -adjustable throw button with lock ring -serialized engraving -smok-e mountain logo engraved


Lieferung erfolgt in schöner Verpackung wie man es gewohnt ist aus dem Hause Smok E Mountain vertig Montiert und Ready to Vape !



Guidelines : Full mechanical units are for advanced users. Make sure the atomizer you are using has a protruding bottom positive pin for better and safer contact.

Battery positioning : 26650 battery is preferred to be positioned upright. Positive pin on the upper side (top cap), and negative in the bottom part (firing switch).

DO NOT STACK dual batteries in a single mod, this technique is of high risk for battery shortage/leakage. The mod is capable of the stress, but a slight difference in voltage and amperage for the two batteries might result to battery failure.

We do suggest a 0.2ohms for the minimum build for safety precaution. Go below the minimum ohm requirment at your own risk.

Make sure to charge your batteries well, and do not use batteries when they are below 3.7volts.

Make sure your batteries are well wrapped and has no open exposure that may contact directly the walls of the tube. Even though the top cap and switch is well insulated, the safety of the users is our prime concern.

Maintenance : (for Copper, SS, Brass, Titanium ONLY) Full mechanical mods are to be cleaned every several weeks after use. It usually depends on usage as dust will accumulate in the threadings of the mod. Use metal polish and a clean cloth to remove accumulated dirt.

Copper pins are also prone to tarnish and must be polished once a month for better conduction of the mod.

(For Brass Glazed, and Rhodium Plated) Use only alcohol for cleaning of threads and polishing of mod.

Using of stronger chemicals such as metal polish for cleaning may result to rub off the ceramic coating(for brass glazed), or the Rhodium plating (for rhodium plated) material